Paxar Monarch 9805 Uživatelský manuál

ONLINE TABLETOP PRINTERTHERMAL DIRECT ORTRANSFERON-DEMAND ORCONTINUOUSPEELS LABELSPRODUCES 4" X 6" IMAGESMonarch9805 PrinterTC9805OI Rev.

Adjusting Print ContrastYou may need to adjust the print contrast if your printing is too dark ortoo light. Having the correct contrast is important

Clearing Label JamsIf a jam occurs, the Supplies light on the printer’s front panel blinks.1. Turn off the printer. Open the cover and printhead asse

cotton swab or dry cloth acrossit. Make sure the platen roller isclean all the way around.6. Rub the cotton swab across thepeel bar, printhead, and s

5. Lift the printhead assembly usingthe printhead tab and push backuntil the printhead assembly clicksinto place.6. Carefully unplug the cable from th

TroubleshootingProblem ActionError messageappears duringstartup.Turn off the printer, wait fifteen seconds and thenturn on the printer. Call Technica

Common ErrorsError Description025 String length is outside the range 0 to 2710.101 The format referenced by batch is not in memory.409 The printer mem

Error Description758 Either the supply is not seen or the on-demand sensor isbroken. Check for a label jam, clear the supply path, or reloadsupplies.

For Thermal Direct 40° to 104° F (4° to 40° C)Print Speed: 2.5 ips (64 mm) for all serial bar codes and 4.0 ips(102 mm). 6.0 ips (152 mm) is availabl

16

Each product and program carries a respective written warranty, the onlywarranty on which the customer can rely. Monarch reserves the right to makech

Connecting the Power Cable1. Plug the power cable into thesocket. Plug the other end ofthe cable into a groundedelectrical outlet.2. Turn on the prin

Printer Status LightsPower: The printer shows a steadygreen light when it is on.Supplies: The printer shows a blinkingamber light when it is out oflab

Loading LabelsThermal Direct Supplies that do not require a ribbon for printing.Thermal Transfer Supplies require a ribbon for printing. Somemodels m

For fan-fold supplies, Lay the labelstrip over the supply holder andacross the supply guide so that afew inches extend past the front ofthe printer.

3. Feed the backing paper overthe peel bar.4. Feed the backing paper throughthe lower opening of the exitcover. Close the exit cover.Pull down on the

Loading RibbonIf the ribbon reels continue to turn when you change a ribbon, pressPause to stop the reels from turning. You can also change the ribbo

10. Tape the ribbon to the take-upcore. Do not tape theribbon to the take-up reel.11. Rotate the take-up core untilthe leader is past theprinthead an