Paxar Mobile Work Station (MWS) Monarch 9878 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Tiskárny Paxar Mobile Work Station (MWS) Monarch 9878. Paxar Mobile Work Station (MWS) Monarch 9878 User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - Work Station

Monarch™9878™ MobileWork Station(MWS™)TC9878OI Rev. AD 12/07 ©2004 Paxar Americas, Inc. a subsidiary of Avery Dennison Corp. All rights reserved.

Strany 2

Connecting the CablesMake sure the charger and battery cables, and power cord are properlyconnected. Follow the steps below if you need to connect th

Strany 3

5. The charger’s status lights should be visible through the cut-out in theleft-side panel. See Chapter 3, "Changing the Batteries" for mor

Strany 4

7. Plug the heavy-duty power cord into the external power socket on theoutside panel of the MWS.Do Not plug the external power cord into a wall outlet

Strany 5 - TABLE OF CONTENTS

Connecting a PrinterContact your Monarch Representative for instructions on attaching aMonarch® printer to the MWS.Using other Monarch® PrintersYou ca

Strany 6

Connecting the 9462/9465 Charger1. Place the charger on the top or bottom shelf.2. Using a 5/32-inch (4 mm) Hex key (wrench), open and remove the lid

Strany 7 - GETTING STARTED

CHARGING THE BATTERIES 3This chapter describes how to¨ charge the batteries¨ change the fuses.The battery charger for the MWS is a fully automatic,mai

Strany 8 - Calling Service

Important Charging InformationWARNINGDANGER! RISK OF ELECTRICAL AND FIRE HAZARD.CERTAIN ACTIONS MAY RESULT IN DEATH, SERIOUSINJURY, SHOCK, OR BURNS.¨D

Strany 9 - ABOUT THE MWS 2

About the Battery ChargerA cut-out in the left-side panel allows viewing of the charger’s status LEDs.¨ Store the charger in a dry area not subject to

Strany 10 - Connecting the Cables

Battery LifeIf you leave the battery charger plugged in and constantly chargingwhen the MWS is not in use, the battery life is maximized for theapplic

Strany 11 - Status LEDs

Use the following table to read the charger’s LEDs (indicator lights).LED Status8-10A6-8A4-6A2-4AThe red lights indicate the charging rate. Deeplydis

Strany 12 - External

Each product and program carries a respective written warranty, the only warranty onwhich the customer can rely. Paxar reserves the right to make chan

Strany 13 - Connecting a Printer

Frequency of Charging/Run-Time GuidelinesThe following information is approximate and should be used forreference. Many factors effect an individual

Strany 14 - Using Other Printers

For example, if you had 60 hours of use between charges and now have 30hours of use between charges, this is an indication that the batteries needrepl

Strany 15 - CHARGING THE BATTERIES 3

4. Insert the proper voltage fuse in each fuse holder. Each fuse is labeledas 20A, 30A, 50A, or 80A.Fuse DescriptionF1 20 A ATO (from BAT2 to the

Strany 16

POWER OPTIONS 4Your MWS was ordered with one of these power options:¨ 12VDC/115VAC 300W AC Power Inverter ¨ 24VDC/DC/DC Converter (12VDC out)¨ 24VDC/1

Strany 17 - About the Battery Charger

About the InverterThe power inverter is only 115V. The AC power inverter uses batterypower, which may require more frequent charging of the batterie

Strany 18 - Battery Life

You may need a UL/CSA listed power strip inside the powercabinet to provide AC power to more than one device. Do Notstore anything else inside the po

Strany 19 - Charging the Batteries 3-5

Using the Remote SwitchThe MWS On/Off switch should be used as a remote switch to turn theinverter ON or OFF. If ordered with the inverter option, yo

Strany 20

PRINTING 5To print supplies from a Monarch® 9825ä or 9855ä printer on the MWS:1. Turn on the MWS power supply and turn on the printer. You will seePR

Strany 21 - Changing Fuses

About Sleep ModeIf the Monarch® 9800ä printer is inactive for longer than 30 seconds, theprinter goes into sleep mode to conserve battery power. Whil

Strany 22 - About the Charger’s Fuse

SPECIFICATIONS AMobile Work Station (MWS) Height: Approximately 37 inches (940 mm) depending on selected optionsTop Width: 20 inches (508 mm)Wheel Bas

Strany 23 - POWER OPTIONS 4

Paxar Barcode Product Limited WarrantyThank you for purchasing a Monarch 9878 Mobile WorkStation. Paxar warrants that your product will befree from

Strany 24 - About the Inverter

Batteries ¨ (1) 12-volt, 55 amp-hours, deep cycle battery¨ (2) 12-volt, 55 amp-hours, deep cycle batteries¨ Sealed lead-acid, non-venting (safety vent

Strany 25

24VDC ModelsInput 117VAC 60Hz, 320 VA (Volt Amps)IEC connectionOutput 24 Volts, 8 Amps DC¨ Reverse polarity and short circuit-proof¨ Temperature compe

Strany 26 - Using the Remote Switch

1000W Inverter Input Voltage 21 to 30VDC (24V)No Load Current 0.75AFrequency(Switch Selected)50/60 Hz ± 0.05%Output Voltage 110VAC +-5%Output Power 1

Strany 27 - PRINTING 5

WIRING DIAGRAMS BThis appendix contains wiring diagrams for the various power options:¨ 12VDC/115VAC 300W AC Power Inverter ¨ 24VDC/DC/DC Converter (1

Strany 28 - About Sleep Mode

12VDC/115VAC 300W AC Power InverterB-2 Wiring Diagrams

Strany 29 - SPECIFICATIONS A

24VDC/DC/DC Converter (12VDC Out)Wiring Diagrams B-3

Strany 30 - Chargers

24VDC/115VAC 300 Watt Power InverterB-4 Wiring Diagrams

Strany 31 - 300W Inverter

24VDC/115VAC 1000 Watt Power InverterWiring Diagrams B-5Batt. #2PART#12652355AhCHARGER 24 VoltPART# 126803+24VTERM. BLCKGND80AMP MAXIE fuse24V_SW+

Strany 32 - 1000W Inverter

Visit www.paxar.com for sales, service,supplies, information, and telephone numbersfor our locations throughout the world.TOLL FREE:1-800-543-6650 (In

Strany 34 - B-2 Wiring Diagrams

TABLE OF CONTENTSGETTING STARTED ...1-1Audience ...

Strany 35 - Wiring Diagrams B-3

PRINTING ...5-1About Sleep Mode ...5-1SPE

Strany 36 - B-4 Wiring Diagrams

GETTING STARTED1Use the Monarchä 9878ä Compact Mobile Work Station (MWSä) for mobile printing either in-store or in retail centers. The in-store mode

Strany 37 - Wiring Diagrams B-5

Safety PrecautionsFollowing symbols are used in this manual to show importance of using the MWS safely.WARNINGFailure to follow the guidelines marked

Strany 38 - 1-800-363-7525 (In Canada)

ABOUT THE MWS 2The Mobile Work Station is shipped assembled. Use this chapter to verifythe cable connections.Check inside ALL packaging material. Ma

Komentáře k této Příručce

Žádné komentáře