Paxar J640 Uživatelský manuál stáhnout pdf

J640/J641 Operator’s Handbook Addendum

This addendum describes how to load continuous strip labels into

your printer and how to clean your printer using the cleaning pen

provided. Read this addendum and store it with your Operator’s

Handbook.

Loading Continuous Supplies–––––––––––––––––––––––––––––––––

Use only paper labels when using this loading method. Also, before

loading labels, make sure the label path is clean. See Chapter 4,

"Care and Maintenance," in your

Operator’s Handbook

First follow steps 1-4 of "Loading for Peel Mode," in Chapter 2 of

your

Operator’s Handbook

. After you complete step 4, follow the

steps below:

1. Feed 4"-5" of the label strip

through the upper opening in

the label guide (Figure 1).

2. Close the printer.

3. Separate the label from the

backing paper (Figure 2).

4. Use the tear bar to tear the

label so it is square with the

backing paper. Don’t tear the

backing paper (Figure 2).

5. Open the printer.

6. Pull the backing paper out of

the upper opening in the label

guide and feed it through the

lower opening.

7. Back up the leading edge of

the label so it rests 1"-2"

behind the black rubber roller.

Lower

Opening

Label

Guide

Upper

Opening

Figure 1

Label

Tear

Bar

Backing

Paper

Figure 2

1 2

Operator’s Handbook 1

Shrnutí obsahu

Strany 1 - Operator’s Handbook

J640/J641 Operator’s Handbook AddendumThis addendum describes how to load continuous strip labels intoyour printer and how to clean your printer using

Strany 2

If you don’t back up the label so it rests behind the rubber roller, thelabel could get stuck to the ribbon during printing.8. Center the backing pape

Komentáře k této Příručce

Žádné komentáře

Paxar J640 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Tiskárny Paxar J640. Paxar J640 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Tiskárny Paxar J640